This page describes the checks a build goes through in the MSFREEZ workshop in October Gardens, Giza. It is a description of process, not a promise of a specific result: what a system achieves depends on its hardware, its case, the workload and the temperature of the room it runs in. Where a figure would be needed to make a claim meaningful, we record it on your build rather than publish it here.
Every plan starts as a written parts list checked against the manufacturers' own fitment documentation and against physical measurements of the case. GPU water blocks are the most common failure point here, because a block is designed for a specific board layout rather than for a marketing name, so the exact card model is confirmed before it is ordered.
Radiator and fan clearance, port orientation, tubing routes and the number of fittings needed are all resolved at this stage. Finding a conflict on paper costs nothing; finding it mid-assembly costs parts and time.
Assembly is done in stages with checks between them rather than as one continuous run. Mounting pressure on blocks is checked for even contact, O-rings are inspected and seated before fittings go on, and tubing is confirmed as fully home rather than merely gripped.
Cable routing is treated as part of the cooling work, not decoration: obstructed airflow paths and cables that block future service access are corrected before the loop is filled.
A filled or pressurised loop is tested while the components have no power applied, so any fault appears while nothing is at risk. Purpose-made pressure testing shows a small loss as a pressure drop before any liquid becomes visible, which is why it is preferred over simply looking for wet spots.
We do not publish a fixed test duration, because the honest answer depends on loop size and method: the loop is observed long enough for a slow loss to reveal itself, and any change to tubing routing after that point returns the build to this step. No liquid-cooled system can be described as risk-free — testing before power-on removes the most damaging failure mode, and we say so plainly rather than promising zero risk.
Once the loop is filled and air has been worked out, the system runs sustained workloads while temperatures, clock behaviour and power draw are logged. What we look for is stability: whether clocks hold, whether the machine stays responsive, and whether anything behaves differently as the system heats up.
Short benchmark scores are not the goal. A machine that produces one impressive number and then throttles under a long render or a long gaming session has not passed anything useful.
Every temperature reading is recorded together with the room temperature at the time it was taken. Without that, the number cannot be interpreted: no cooler of any kind brings a component below the temperature of the air feeding it, so the same build reads differently in a cool room and in an Egyptian summer afternoon.
This is also why MSFREEZ does not quote a temperature drop before seeing a machine. We record readings on your finished build, note the ambient conditions, and use them as a baseline you can compare against later if something changes.
Before a system leaves the workshop it gets a last pass: fittings re-checked, coolant level confirmed, fan and pump behaviour listened to, filters and panels refitted, and the machine restarted from cold to confirm it comes up cleanly.
Handover includes what to watch for — a new pump noise, a gradual rise in temperature at similar room conditions, a change in coolant colour — because those are the signals that bring a loop back for service before a problem becomes damage.
We do not publish measured temperature figures, performance percentages, pass rates or fixed test durations, because a number without its exact hardware, workload and ambient conditions is not evidence of anything. Commercial terms — pricing, cover and schedule — are confirmed on your quote and invoice rather than stated sitewide.
Home · Services · Build concepts · Guides · Glossary · How we test · Contact
MSFREEZ · 207 El Rehab Commercial Mall, October Gardens, Giza, Egypt · +20 107 002 8289